Hallo
ich bin gerade verzweifelt. Habe heute ein Downgrade durchgeführt von
59....449 auf 56...513 und während des prozess ging aufeinmal das Licht
im Auto an und der upload was not sucessfull. Jetzt ist mein MZD
Bildschirm schwarz und ich höre nur noch musik.
Wer kann mir da weiterhelfen?? Wie kann ich den Prozess neustarten??
Habe übrigens zuerst die Reinstall Datei gewählt bin bis 29% gekommen.
ZitatAlles anzeigenIch habe auch einen factory reset durchgeführt leider auch kein Erfolg gehabt... [Blockierte Grafik: https://www.mazda-forum.info/styles/uix/xenforo/smilies-vb/icon_sad.gif]
BLACK TOUCH-SCREEN : RESTORE FACTORY SETTINGS (NO GUARANTEES)
Use this option if something goes wrong during Firmware Updating and or
you have an unresponsive black or blank touch-screen, this will not
work if you already have bricked the CMU.
IF you can hear radio still on this ‘may’ work.
Put car into Amber 'ACC' Light ON (Accessory Mode)Do Not Start Engine.
Wait 30 seconds for Connect to settle as you cannot see the touchscreen as it is blank or black.
Perform these setting inputs *below precisely as you are flying blind..
IF you make an input error you must turn off ACC system and
power down car SLEEP CMU below and do #1 to #3, and then
repeat BLIND setting input process *again.
*PRESS "Home Button" above Commander Knob ONCE.
*TURN Silver Command Wheel 2 clicks to the Right.
*PRESS Down on Commander Black Knob ONCE.
*SLIDE-PUSH move Commander Knob 6 times to the Right.
*TURN Silver Command Wheel 5 clicks to the Right.
*PRESS Down on Commander Black Knob ONCE.
*TURN Silver Command Wheel 1 click to the Right.
*PRESS Down on Commander Black Knob ONCE.
After a while the loading of screen and MAZDA logo should occur. If
Black Touch-Screen continues you may need your CMU hardware repaired or
replaced.
Ich habe in der vorgebenen Zeitspanne <15 Minuten die Bremse betätigt (Schaltgetriebe) war das vllt falsch?
</article>